Name:
Casper
Mods:
"- Dremeled the crap out of both the Metal
and Plastic on the front of my case to get unrestricted
airflow for a 120mm fan. The Fan shroud you
see is the top of a Super Big Gulp.
- In the back is 1 80mm fan mount where I removed
the sheet metal fan cover that restricts the
airflow (with a dremel of course) and then put
in a grille like the one in front.
- I have 2 40GB Maxtors behind the 2 upper fans.
That was made by simply cutting up 2 bay covers
for the fans, and then the screws of the fans
hold the 2 pieces to each other. I also (I told
you it was ghetto) didn't spring for CD to HD
rails, so instead of each drive being mounted
in the middle, they are both mounted on the
left side with 2 screws and then the right side
is hanging loose.
Because
of that, I plan to hack up 2 more bay covers
and go from the 2 40mm fans to 1 80mm fan offset
on the left side, and then put in 2 Temp Sensors
on the right side of the new 80mm fan. This
way the Fan blows right across the drives, and
puts out the same if not more airflow, and then
I can get the temp sensors on the front as well.
Nothing
special, but it does the job for me."
Our
comments: Classic of functionality over appearance.
Good work Casper!
|
